When the equipment is in operation, some failures often make people feel helpless, and the troublesome troubleshooting may affect the life cycle of the entire machine. What I want to share with you is what should I do if the heating strip of the vacuum packaging machine is broken?
1. Remove the outer insulation cloth first.
2. If the heating belt is loose, the copper nut at one end may be loosened, and then the copper screw is turned to tighten the heating belt, and then the copper nut is tightened.
3. Remove the heating wire and loosen the pins or bolts of the unchanged phenolic board.
4. Remove the heating bar and the partition.
If the heating belt cannot be used, you need to unscrew the nut on both ends, remove the copper screw, insert one end of the replaced heating belt into the slot of the copper screw, put it into the heating strip and wind the copper screw for more than one turn, adjust The heating strip is located in the middle of the width of the heating strip. Tighten the copper nut, and then insert the copper screw at the other end into the heating strip as described above (if the heating strip is too long, more than part can be subtracted), turn the copper screw to tighten the heating strip , Tighten the copper nut.
After understanding these skills, don't panic when the heating strip of the vacuum packaging machine is broken, just follow the 4 points shared above.
Address: Longwu Industrial Zone, Shangfen Community, Minzhi Street,
Longhua New District, Shenzhen
Tel: 139 2462 2408
QQ: 378912250
E-mail: support@gokilife.cc